Home | Ask A question | Plumbing | Heating | Local Contractors | Free Listing | Answered Questions | Donate |

Now you can remove the 2 screws from the overflow tube and install the linkage and trip lever plate then reinstall the screws, make the screws snug, go back down below the tub and reinstall the trap. (you may find the waste assemble off center and to one side, just pull it back to line it up with the trap, install the trap and tighten all the nuts for the trap.

Screw in new Gerber spud

Next

Plumbing Problems Ask A Question Now Aerator
Delta Faucets Moen Faucets Gerber Faucets
No Tile Repair Basket Strainer Garbage Disposal
Drain Problems Toilet Flapper Repair Toilet Fill Valve
Bathtub Drain Shallow Jet Pumps Washing Machine
Hot Water Heaters Heating Problems Boiler Relief Valves
Burnham Boilers Peerless Boilers Weil McLain Boilers
Taco Zone Valves Taco Circulators Honeywell Zone Valves
Oil Burners Expansion Tanks Watts 1156 Boiler Feed
Remove Air From Boiler Replace Blower Motor What's Wrong With This
Disclaimer Contact Me Feed Back
About me Bio Clean Annoyance Fee
Sitemap Privacy Policies Find a Plumber
By Thomas Petito Reardon Email listing for Plumbing and HVAC
x