masterplumber.net logo

Home | Ask A question | Plumbing | Heating | Local Contractors | Free Listing | Answered Questions | Donate |
Delta Tab line up
This is a tricky part, as I said before, the assemble of the ball, boot and plastic retainer will push back, this will cause the tab on the plastic retainer to come out of the notch, be mindful of this when putting the nut on, you will have to take your hand off of the assemble to install the nut, unce you have the nut over the assembly, you will need to make sure the slot in the plastic retainer is in a perfect vertical position, make sure as you tighten the nut, that the slot stays vertical, and does not move to the right.
The nut has a natural stopping point, do not try to make it tighter, this wall cause the same problem as, trying to force a tight nut loose. 

 

|About me | Privacy policies | Site Map | Contact me | Feed Back | Disclaimer | Annoyance Fee? |